EB1104NET Remote Access

Remote Access within the LAN

1. Setup the EB1104NET per installation instructions, so that the unit is up and running properly.

2. Connect the EB1104NET to your LAN.

3. Stop the Recording by pressing the Stop button on the EB1104NET Front Panel.

4. Enter the OSD Main Menu by using the Menu button on the EB1104NET Front Panel.

5. Press the Down button until Network Setup is highlighted then press the Select Button.

6. In Network Menu, set “ACCEPT CLIENT” to Yes.

7. In Network Menu, verify that the “IP ADDRESS” is correct. If your Gateway is 192.168.0.1, then assign an IP address within 192.168.0.2 to 192.168.0.255. Be sure that you are not using an IP that is already in use by another system on the LAN.

8. In Network Menu, verify that the “SUBNET MASK” is the same as your Gateway Subnet Mask. Typically, the Subnet Mask is 255.255.255.0.

9. In Network Menu, verify that the “GATEWAY” IP is correct. Typically, the Gateway is 192.168.0.1.

10. On the PC that will be Remote Accessing the EB1104NET, you will need to install the client software downloadable from this webpage: http://www.aver.com/support/faq_eb1104net.shtml

11. Once the Client software is installed, there is an EBServer Icon on your Desktop. Double click to load this to your System Tray.

12. Open an Internet Explorer Windows, and type in http://127.0.0.1/EB1104NET.HTM

13. If a Windows Security Alert popup, click unblock.

14. Install the ActiveX Client.

15. Click on the Connect/Disconnect button at the upper –right hand corner of the webpage to popup the Login window.

16. Change the DVR IP to the correct IP of the EB1104NET, and enter the password. The default password is 111111.

17. If everything is done correctly, the upper-right hand corner should indicate the DVR IP that is connected.

To Remote Access from the Internet

1. Verify that you can remote access within the LAN using the steps from the previous pages.

2. On your Router, Port Forward port 14337 and 14339 to the EB1104NET on your LAN. Please read the FAQ if you are not familiar with Port Forwarding. http://support.aver.com/faq.php?do=article&articleid=208

3. To install and start up the remote client software via loopback method, follow Step 12 to 14 on page 2. Otherwise, if you are setting up a PC for EB Server Host, then Port Forward port 80 to that EB Server Host PC. Setting up a Server allows other PCs to just connect to the server to install the remote client ActiveX, rather than having to download the EBServer software, install it and run it in a loopback.

4. On the PC that will be doing the Remote Access, follow steps 10 through 15 from the previous pages.

5. Enter the Internet IP Address (the External IP Address that is assigned to your Gateway from your ISP provider) for the DVR IP, and enter in the password. By default the password is 111111.